Hitachi HDS725050KLA360 Specifications - Page 62
logical head default
View all Hitachi HDS725050KLA360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Notes: 1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL mode the drive address is determined by AT interface signal #28 CSEL as follows: • When CSEL is grounded or at a low level, the drive address is 0 (Device 0). • When CSEL is open or at a high level, the drive address is 1 (Device 1). 2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selection of Device or Cable Selection mode. 3. The shipping default position is the Cable Select position. 7.1.3.2 15 logical head default The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device1 (Slave) Present setting 15 logical heads instead of default 16 logical head models. IGECA HFDB IGECA HFDB IGECA HFDB IGECA HFDB DEVICE 0 (Master) DEVICE 1 (Slave) CABLE SEL DEVICE 1 (Slave) Present Notes: 1. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F. In the CSEL mode the drive address is determined by AT interface signal #28 CSEL as follows: • When CSEL is grounded or at a low level, the drive address is 0 (Device 0). • When CSEL is open or at a high level, the drive address is 1 (Device 1). 2. In CSEL mode, installing or removing the jumper blocks at A-B or C-D position does not affect any selection of Device or Cable Selection mode. Deskstar 7K500 and Deskstar E7K500 Hard Disk Drive Specification 48