Hitachi L19D103 Owners Guide - Page 23
Preparation, Status display of disc, Playback procedure
View all Hitachi L19D103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
ENGLISH NOTE: • Selectable picture format aspect ratios may vary depending on the input source or broadcast signal. • Picture Size menu also can be displayed by pressing ASPECT on the remote control. Natural In some cases, this image will display the size of standard 4:3 with a black side bar. Cinema Wide1 (for 4:3 format programs) To fill the screen, the right and left edges are extended. However, the center of the picture remains near its former ratio. The top and bottom edges of the picture may be hidden. Preparation The following pages describe the setup/operation in DVD mode. Preparation Before DVD/CD operation, please make the following preparations. 1 Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet. • If the AC cord plug is plugged in for the first time, wait for about 5 seconds before pressing POWER. NOTE: • When connecting to other equipment, unplug the unit from the AC outlet. 2 Press POWER on the unit or on the remote control to turn on the unit. The POWER indicator will change to green. • Each time you turn the unit ON, the TV/DVD starts from the TV mode. • When using an amplifier, switch on the amplifier. 3 Press TV/DVD to select DVD mode. The DVD startup screen will appear on the screen. Cinema Wide2 (for letter box programs with subtitles) To fill the width of the screen, it is extended horizontally. However, it is only slightly extended at the top and the bottom. The top and bottom edges of the picture may be hidden. Cinema Wide3 (for letter box programs with subtitles) To fill the width of the screen, it is extended horizontally. However, it is only slightly extended at the top and the bottom. The top and bottom edges of the picture may be hidden. NOTE: • If the unit does not operate properly: Static electricity, etc., may affect the player's operation. Disconnect the AC power cord once, then connect it again. Status display of disc Press DISPLAY. The status display of the disc will appear on the screen. DISC OPERATION ELAPSED TIME TOTAL TIME A B C D E F G A B C D E F G Full (for 16:9 source programs) Full will display the picture at the maximum size. Native (for PC mode only) Detects the resolution of the signal of the image and it will be shown on the screen with same amount of pixels. NOTE: • Some High Definition and/or Digital broadcasts may not allow you to change the picture format aspect ratio. • In HDMI or COMPONENT mode with a scanning rate of 720p, 1080i or 1080ip, only the Cinema Wide2 and Full are available. • In PC Mode, only the Natural, Full and Native are available. In PC Mode (WXGA), only the Full and Native are available. TITLE NO. DVD Title 1/3 1/1 Eng Dolby Digital 1/1 00:15:25 01:41:39 Chapter 2/24 1/2 Eng CHAPTER NO. ANGLE NO. SUBTITLE LANGUAGE AUDIO LANGUAGE A KIND OF AUDIO To make the status display screen disappear, press DISPLAY again. Playback procedure 1 Press TV/DVD to select DVD mode. 2 Place the disc in the disc slot with the label side facing forward. (If the disc has a label.) Hold the disc without touching either of its surfaces, align it with the guides, and place it in position. 3 On the screen, " " changes to "Reading" and then playback will commence. • A menu screen may appear on the TV screen, if the disc has a menu feature. In this case, press or ENTER to operate a menu feature. Reading 23