Hitachi L32A404 Owners Guide - Page 12
Quick Setup Guide
View all Hitachi L32A404 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Quick Setup Guide Perform the following steps to quickly setup your new Hitachi LCD Television Set. 1. ANTENNA CONNECTION Unless your LCD Television is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient. a). VHF (75-Ohm) antenna/CATV (Cable TV) When using a 75-Ohm coaxial cable system, connect the CATV coaxial cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna, connect the coaxial cable to the same AIR/CABLE terminal. AIR/CABLE To outdoor Antenna or Cable TV (CATV) System To AIR/CABLE Terminal RGB Rear Panel Jack RGB 2. CONNECT YOUR NEW HITACHI LCD TV TO THE POWER SOURCE a). Connect the power cord to your TV set and secure it with the wire Clamp (see page 7) . c). The Indicating Lamp will light red (Standby modes) and then light blue (picture is shown). Wire Clamp Indicating Lamp b). Connect the power code to the AC outlet. 3. POWER ON/OFF YOUR NEW HITACHI LCD TV P.MODE S.MODE MTS/SAP ASPECT Press the POWER button on the remote control or the POWER 123 4 button on the Side Control Panel to power on/off the LCD TV. 456 789 NOTE If the Indicating lamp is off, the POWER button on the remote control will not operate. Please 0 LAST CH ENTER VOL MUTE CH E.SAVE CC SLEEP FAV.CH or 5 MENU INPUT make sure that the power cord is plugged to the 2 AC outlet. SELECT EXIT INFO For Stand-By Power OFF 3 1 CLU-4591AV 4. FOLLOW THE SETUP WIZARD INSTRUCTIONS ON NEXT PAGE 12