Hitachi M12VC Instruction Manual - Page 10
Installing And Removing Bits, Warning - router lift
UPC - 717709008298
View all Hitachi M12VC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English INSTALLING AND REMOVING BITS WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble. 1. Installing bits (1) Remove the motor housing from base as follows. (a) Open the lever. (Fig. 2) (b) While holding the base, turn the motor housing counterclockwise. (c) Turn it until the pin in the base is disengaged from the groove in the motor housing. Lift the motor housing free from the base. (2) Clean and insert shank of bit into the collet chunk until shank bottoms, then back it out approximately 1/16" (approx. 2 mm). (3) With the bit inserted and 16 mm wrench holding the armature shaft, use the 23 mm wrench to firmly tighten the collet chuck in a clockwise direction (viewed from under the router). (Fig. 3) (4) When using the 1/4" diameter shank bit, replace the equipped collet chuck with the one for 1/4" diameter shank bit which is provided as the standard accessory. CAUTION: ⅷ Ensure that the collet chuck is firmly tightened after inserting a bit. Failure to do so will result in damage to the collet chuck. 2. Removing bits When removing the bits, do so by following the steps for installing bits in reverse order. Motor Housing Base Fig. 2 Lever Loosen Tighten 23mm Wrench Bit Collet Chuck 16mm Wrench Fig. 3 10