Hitachi M12VC Instruction Manual - Page 14
should return to normal. - dimensions
UPC - 717709008298
View all Hitachi M12VC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
English (3) The bit rotates clockwise (arrow direction indicated on the base). To obtain maximum conformance with the feed directions shown in Fig. 16. Router feed Router feed workpiece Rotation of bit Fig. 16 NOTE: ⅷ Moving the tool forward fast may cause a poor quality of cut, or damage to the bit or motor. Moving the tool forward too slowly may burn and mar the cut. The proper feed rate will depend on the bit size, the kind of workpiece and depth of cut. Before beginning the cut on the actual workpiece, it is advisable to make a sample cut on a piece of scrap lumber. This will show exactly how the cut will look as well as enable you to check dimensions. ⅷ Abnormalities and overloads will trigger the overload protector, and stop operation. Remove the load immediately, and turn the power off, then on. The rotation speed should return to normal. ⅷ Do not use a power generator as the power source. It may cause the rotation speed to fluctuate. ⅷ When using the straight guide, be sure to install it on the right side in the feed direction. This will help to keep it flush with the side of the workpiece. 14