Hitachi NV50AP3 Instruction Manual - Page 20

English 〈Cap (washer) feed unit〉 1 DISCONNECT AIR HOSE. 2 Open the washer magazine cover. Clean the shaft of feed piston (B) and the washer rail. Lubricate the shaft of feed piston (B). 5. WARNING LABEL Change the WARNING LABEL if missing or damaged. A new WARNING LABEL is available from a Hitachi authorized service center. Shaft of feed piston (B) Washer rail CAUTION ⅷ Pull the knob of washer feeder to check if moves smoothly. If it does not move smoothly, the timing for the cap (washer) and nail will be off and the nailing finishing by be poor. Knob Washer feeder 3. Inspecting the magazine and the washer magazine 1 DISCONNECT AIR HOSE. 2 Clean the magazine and the washer magazine. Remove dust or wooden tips which may have accumulated in the magazine and the washer magazine. 4. Storing ⅜ When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid rust. ⅜ Do not store the Nailer in a cold weather environment. Keep the Nailer in a warm area. ⅜ When not in use, the Nailer should be stored in a warm and dry place. Keep out of reach children. Warning label 6. Maintenance chart (See page 21) 7. Operator troubleshooting (See page 21) 8. Service parts list A: Item No. B: Code No. C: No. Used D: Remarks CAUTION ⅷ Repair, modification and inspection of Hitachi Power Tools must be carried out by an Hitachi Authorized Service Center. This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when requesting repair or other maintenance. In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed. MODIFICATIONS: Hitachi Power Tools are constantly being improved and modified to incorporate the latest technological advancements. Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior notice. SERVICE AND REPAIRS WARNING ⅷ Only service personnel trained by Hitachi, distributor or employer shall repair the Nailer. ⅷ Use only parts supplied or recommended by Hitachi for repair. All quality Nailers will eventually require servicing or replacement of parts because of wear from normal use. NOTE: Specifications are subject to change without any obligation on the part of HITACHI. - 20 -