Hitachi WT-1 User Guide - Page 16

StarBoard WT-1 Usage Procedures 2.2 Using the Stylus Pen This section describes how to use the Stylus pen. 2.2.1 Basic Stylus Pen Operations The stylus pen can be used in the same way as a mouse. Under the stylus pen's default settings, the pen tip button is set to correspond to the left mouse button. When Windows is open, the pen tip button may be used to perform the following mouse actions. • Clicking Tap the pen tip against the tablet operating area with a suitable amount of pressure and then release it quickly. • Double-clicking Double tap the pen tip against the tablet operating area with a suitable amount of pressure and then release it. • Dragging Press the pen tip against the tablet operating area with a suitable amount of pressure and then move the pen while keeping it pressed against the tablet operating area (without releasing it from the tablet operating area). The pen can be angled at up to 30°from vertical but it may not work correctly, if the pen is tilted at an angle greater than 30°. 2.2.2 Stylus pen Settings The stylus pen has one pen tip button, and two side buttons. Mouse actions can be assigned to these three buttons. The default button settings are summarized in the following table. Button Pen tip Side Button No.0 Side Button No.1 User action Press the pen tip against the tablet operating area Press the button with the pen tip very slightly above the tablet operating area (5 mm or less) Same as above Corresponding mouse action Mouse left-click Mouse left double-click Mouse right-click Pen tip Side Button No.1 Side Button No.0 2-5 English