Hitachi c8fb2 Instruction Manual - Page 20
Groove cutting procedures, Cutting depth adjustment procedure
UPC - 717709003415
View all Hitachi c8fb2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
English (2) Setting to cut crown moldings at positions w and e in Fig. 28 (see Fig. 31): q Turn the turntable to the left and set the Miter Angle as follows: * For 45°type crown moldings: 35.3° ( mark) * For 38°type crown moldings: 31.6° ( mark) w Tilt the head to the left and set the Bevel Angle as follows: * For 45°type crown moldings: 30° ( mark) * For 38°type crown moldings: 33.9° ( mark) e Position the crown molding so that the lower surface (B in Fig. 27) contacts the fence as in Fig. 32. Head Head Bevel Angle Scale Bevel Angle Scale q e r w Fence Fence Miter Angle Scale Turntable Fig. 29 Base Base Miter Angle Scale Turntable Fig. 31 Fence A B Table on Base Fence B A Table on Base Fig. 30 11. Groove cutting procedures Cut grooves with saw blade Fig. 32 8mm 8mm Wing Nut Depth Adjustment Bolt a b Fig. 33 Bottom Line of the Groove Turntable Fig. 34 Grooves in the workpiece can be cut as indicated in Fig. 33 by adjusting the 8mm depth adjustment bolt. Cutting depth adjustment procedure: (1) Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand. (2) Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the base (see b in Fig. 33). (3) The 8mm wing nut must be properly tightened after the adjustment has been completed. NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion with a chisel. 20