HoMedics BPA-150 User Manual - Page 9

Applying The Cuff

Get HoMedics BPA-150 PDF manuals and user guides View all HoMedics BPA-150 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

FiAttlolcaounfwfidft rsbyoeeooctumuwrreefaeolrynrm. 2t.hfeincgueffrs (0.28~"~3 1c.m2") Cemnitdedrletuobfeaorvme.r Po0s.a8ibt-io1ov.n2ecienulcfbhfoeewsd(.g2e-3cm) APPLYING THE CUFF 1. If the cuff is not assembled, pass the end of the cuff furthest away from the tubing through the metal D-ring in order to form a loop. End of cuff D-ring 2. Plug the cuff tube into the left side of the unit. Insert plug here 15 3. Remove tight fitting clothing from around your upper left arm. 4. Position cuff edge 0.8-1.2 inches (2-3cm) above elbow. 5. Center tube over middle of arm. 6. Pull the end of the cuff so that it tightens evenly around your arm. Press the hook and loop material together to secure. Allow room for 2 fingers to fit between the cuff and your arm. 7. Lay your arm on a table (palm upward) so the cuff is at the same height as your heart. Make sure the tube is not kinked. 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
16
15
2~3 cm
(0.8”~1.2”)
Position cuff edge
0.8
1.2 inches (2
3cm)
above elbow.
Fit cuff
Allow
to fit
and
Cent
mid
Insert plug here
3. Remove tight fitting clothing from around your
upper left arm.
4.
Position cuff edge 0.8-1.2
inches (2-3cm) above elbow.
5.
Center tube over middle of arm.
6.
Pull the end of the cuff so that it tightens
evenly around your arm.
Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between
the cuff and your arm.
7. Lay your arm on a table (palm upward) so the cuff is
at the same height as your heart. Make sure the
tube is not kinked.
APPLYING THE CUFF
1. If the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the
metal D-ring in order to form a loop.
2. Plug the cuff tube into the left side of the unit.
D-ring
End of cuff