HoMedics BPA-200H User Manual - Page 29

TROUBLESHOOTING If any abnormality arises during use, please check the following points SYMPTOMS POSSIBLE CAUSES CORRECTION Unit does not turn on when the START/STOP button is pushed. Batteries have run down. Battery polarities have been positioned incorrectly. Replace them with four new AA alkaline batteries. Re-insert the batteries in the correct positions. EE measurement error Cuff has been placed symbol shown on display or incorrectly. the blood pressure value is displayed excessively low Did you talk or move (or high). during measurement? Shaking of the arm with the cuff on. Wrap the cuff properly so that it is positioned correctly. Measure again. Keep arm steady during measurement. Er error symbol shown on display - measurement result exceeds measurement range. Did you move during measurement? Shaking of the arm with the cuff on. Measure again. Do not move during measurement. E1 error symbol shown on display Air circuit abnormality. Cuff Check cuff connection. tube may not be plugged Measure again. into monitor correctly. E2 error symbol shown on display E3 error symbol shown on display Inflation pressure exceeding Switch the unit off, then 300 mmHg. measure again. Data error. Remove and reload the batteries. Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page. 28