HoMedics BPW-200-WGN User Manual - Page 9

Date & Time Set Procedure, Applying The Cuff

Get HoMedics BPW-200-WGN PDF manuals and user guides View all HoMedics BPW-200-WGN manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

DATE & TIME SET PROCEDURE 1. To adjust the date/time, press the Set button located on top of the monitor. The display will show a blinking number showing the hour. 2. Change the hour by pressing the button. Each press will increase the number by one in a cycling manner. Press the Set button again to confirm the entry, and the screen will show a blinking number representing the minutes. 3. Change the time and date as described in Step 2 above, using the button to change the numbers and the Set button to confirm the entries. 4. A "0" will reappear as the blood pressure monitor is ready for measurement again. Press the button blinking hour increasing hour confirm the entry repeat process to set time and date 15 APPLYING THE CUFF 1. Remove all watches, wrist jewelry, etc. prior to attaching the wrist monitor. Clothing sleeves should be rolled up and the cuff should be wrapped around bare skin for correct measurements. 2. Apply cuff to left wrist with palm facing up as shown in Fig. A. 3. Make sure the edge of the cuff is about 1/4"~1/2" (1 cm) from the palm as shown in Fig. B. Fig. A Fig. B 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
16
15
Press the
button
blinking hour
increasing hour
confirm the entry
repeat process to set time and date
DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the
Set
button
located on top of the monitor.
The display will show a blinking number
showing the hour.
2. Change the hour by pressing the
button
. Each press will increase the
number by one in a cycling manner.
Press the
Set button
again to confirm
the entry, and the screen will show a
blinking number representing the minutes.
3. Change the time and date as described
in Step 2 above, using the
button
to
change the numbers and the
Set button
to confirm the entries.
4. A “0” will reappear as the blood pressure
monitor is ready for measurement again.
APPLYING THE CUFF
1. Remove all watches, wrist
jewelry, etc. prior
to attaching the wrist
monitor.
Clothing sleeves
should be rolled up and
the cuff should be
wrapped around bare
skin for correct measure-
ments.
2. Apply cuff to left wrist with
palm facing up as shown
in Fig. A.
3. Make sure the edge
of the cuff is about
1/4”~1/2” (1 cm) from the
palm as shown
in Fig. B.
Fig. A
Fig. B