HoMedics MDA-100 User Manual - Page 6

TROUBLESHOOTING PROBLEM Unit will not operate POSSIBLE CAUSE • Unit is not charged Unit seems to be losing suction • U nit is not fully charged • B lack wool filter needs to be replaced. • D iamond tip is not securely installed Diamond tip no longer • T he Diamond Tip has an seems rough accumulation of skin cells. SOLUTION • Charge the unit, placing firmly into the charging base. • P ress and hold the POWER BUTTON for 2 seconds to turn the power on. • Check circuits, fuses, try a different outlet. • Charge the unit, placing firmly into the charging base. • Replace the filter. • Make sure the Diamond Tip is secured tightly to the unit • Clean the debris from the Diamond tip using the included brush. • Deep clean the Diamond Tips in an ultrasonic cleaner (i.e., a jewelry cleaner) to remove excess skin cell buildup. FAQ HOW OFTEN SHOULD I USE THE PRODUCT? It's best to start slowly - usually just once a week, then build up to 2 or 3 times a week if this is comfortable for your skin. WILL IT HURT? No. Treatment should not be painful. Depending on the sensitivity of your skin, you may feel slight discomfort from the diamond tip as it moves across the skin. There could be some short-term redness or sensitivity after treatment, but this will soon subside. If treatment is uncomfortable, you may need to use a lower power setting or switch to the sensitive diamond tip. CAN I USE THE PRODUCT IN COMBINATION WITH ANTI-AGING CREAMS/ SERUMS? If your anti-aging cream or serum contains AHA (or acid) then it should not be used on the same day as the microdermabrasion treatment, but can be used on non-treatment days. Non-AHA (acid free) anti-aging products can be used at any time. 10 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • R eorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receive is connected. • Consult the dealer or an experienced radio/TV technician for help. This class B digital device complies with Canadian CAN ICES-3 (B) /NMB-3 (B). 11