HoMedics PED-1200 User Manual - Page 3

HOW TO USE

Page 3 highlights

HOW TO USE INSERTING THE BATTERIES 1. Open the battery compartment. 2. Insert batteries observing the polarity signs (+ and -) inside the battery compartment. NOTE: The batteries are stacked with one of the batteries behind the other two. 3. Close the battery compartment HOW TO USE HI OFF OFLFO LO 1. Before use, ensure that your feet are clean and dry. 2. Use the switch to select a power setting; 3. For sensitive skin, or softer skin use the LO setting 4. For harder skin use the HI setting 5. Using light pressure place the surface of roller onto the heel or sole of your foot and gradually move the device around to target areas of hard skin. Do not use on a single area for more than 4 seconds at a time. 6. Check the results throughout. Once you are happy with the results turn the switch to OFF. 7. Rinse your feet with clean water & dry before applying your favorite foot cream. Cautions Before use, make sure that the roller is in good condition. Any malformation, distortion or damage may cause skin injury. DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP ROTATING. FOR BEST RESULTS, RUN THE UNIT GENTLY OVER THE SKIN. THIS WILL ENSURE SOFT, SAFE AND SMOOTH REMOVAL OF DEAD SKIN. 4 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13

4
5
HOW TO USE
INSERTING THE BATTERIES
HOW TO USE
1. Open the battery compartment.
2. Insert batteries observing the polarity signs (+ and -) inside the
battery compartment. NOTE: The batteries are stacked with
one of the batteries behind the other two.
3. Close the battery compartment
1.
Before use, ensure that your feet are clean and dry.
2. Use the switch to select a power setting;
3. For sensitive skin, or softer skin use the LO setting
4. For harder skin use the HI setting
5. Using light pressure place the surface of roller onto the heel
or sole of your foot and gradually move the device around to
target areas of hard skin. Do not use on a single area for more
than 4 seconds at a time.
6. Check the results throughout. Once you are happy with the
results turn the switch to OFF.
7. Rinse your feet with clean water & dry before applying your
favorite foot cream.
Cautions
Before use, make sure that the roller is in good condition. Any malformation, distortion or damage
may cause skin injury.
DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP ROTATING. FOR BEST
RESULTS, RUN THE UNIT GENTLY OVER THE SKIN. THIS WILL ENSURE SOFT, SAFE AND
SMOOTH REMOVAL OF DEAD SKIN.
OFF
OFF
LO
LO
HI