HoMedics UHE-CMTF45 User Manual - Page 7
About White Dust, How To Operate
View all HoMedics UHE-CMTF45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ABOUT WHITE DUST Use of high mineral content hard water may cause a white mineral residue to accumulate on surfaces in the room near the humidifier. The mineral residue is commonly called "white dust." The higher the mineral content (or, the harder your water is), the greater the potential for white dust. The white dust is not caused by a defect in the humidifier. It is caused only by minerals suspended in the water. HOW TO OPERATE Insert single pin plug into the top of the humidifier, then plug the adapter into a 120-volt AC electrical outlet. POWER BUTTON Turns humidifier on/off. MIST OUTPUT Mist adjusts from the lowest output (1) to the highest output (3). To increase the mist output, press the mist output button. The corresponding mist level will be lit on the display. Do not point the mist nozzle toward walls or furniture. TIMER Press the timer button until the desired auto-shutoff timer setting is displayed. The timer button will cycle through the following settings: 4, 8, 12 hours and off. To cancel the timer at any time, press the timer button until all LEDs are off. NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting. NIGHT-LIGHT/DISPLAY LIGHTS Press the night-light button to turn the night-light on/off. CLEAN REMINDER The LED above the clean icon will illuminate red indicating it is time to clean the transducer/ultrasonic membrane. See cleaning instructions in the How to clean and care section. Press and hold the timer and night-light buttons until the red light turns off. 7