HoMedics UHE-WM130-BK User Manual - Page 12
Troubleshooting
View all HoMedics UHE-WM130-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
TO CLEAN THE OIL TRAY Open the oil tray and remove the pad. Essential oil pads should be changed when switching to a different essential oil scent. If continuing to use the same scent, set the essential oil pad aside for reuse. Wipe down the inside of the oil tray with a soft cloth. Place the essential oil pad back in the tray and close. NOTE: Leave the essential oil pad out of the oil tray when storing. TO CLEAN THE SURFACE Clean the surface of the unit with a soft, damp cloth. Before storing: Clean the tanks, reservoir, tank caps, and the transducer/ ultrasonic membrane with a 50/50 mixture of white vinegar and water. Be COOL TIMER % RH MIST HUMIDISTAT sure to rinse and let all parts dry completely before storing. Clean the oil tray - + WARM + LAMP with a soft cloth. TIMER - MIST - HUMIDISTAT + After storing: Rinse the tanks, reservoir, ultrasonic membrane, and WARM LAMP essential oil tray with water. Dry completely before filling. Only fill the tank just before operating. TROUBLESHOOTING PROBLEM No power/no mist from spout POSSIBLE CAUSE SOLUTION • Unit is not plugged in • Humidifier not turned on • No power at unit • Low water level • The humidistat setting is lower than the current room humidity • Transducer/ultrasonic membrane needsto be cleaned • Plug unit in • Press the power button to turn the unit on • Check circuits and fuses or try a different outlet • Refill the tank with water • Reset the humidistat to a higher humidity level, or change the mist output to continuous on • Follow Cleaning the Transducer/Ultrasonic Membrane instructions in the Cleaning and Care section 12