HoMedics UHE-WM65 Downloadable Instruction Book - Page 4

How To Use Power ON/OFF Button Warm Mist Button WARM Night Light ON/OFF Button Night Light Illuminated Ring Mist Increase / Decrease Adjustment Knob Fig. 2 Power ON/OFF Button Plug unit in to a 120 volt AC electrical outlet. Press the POWER ON/OFF button to turn unit on. Press the POWER ON/OFF button again to turn unit off. ATTENTION: When the water in the tank is almost empty, the humidifying function will power off to indicate to the user to refill the tank. Mist Adjustment Setting Mist adjusts from Lowest output to Highest output. To increase the mist output, turn the MIST adjustment knob clockwise. To decrease mist output, turn the MIST adjustment knob counterclockwise. Mist Temperature Setting When the humidifier is powered ON, it will be operating on the default setting-Cool Mist. To change the Mist Temperature from Cool Mist to Warm Mist, press the WARM MIST WARM button. The mist temperature will change to Warm Mist, and WARM MIST button will be illuminated red. To change the Mist Temperature back to Cool Mist, press the WARM MIST button again. The mist temperature will change to Cool Mist, and the light in the WARM MIST button will turn off. NOTE: Once warm mist is selected, it will take 20 minutes before the mist becomes warm. Night Light Press the NIGHT LIGHT ( ) button to turn on the night light. The surround around the POWER/MIST knob will glow softly. 6 How to Fill CAUTION: Before filling unit with water, turn the power off and unplug the unit from the outlet. Note: Always use two hands to carry the water tank. Fig. 3 1. Grasp tank handle with both hands and lift up from humidifier base. Remove only one tank at a time. (Fig. 3) Fig. 4 2. Turn the tank upside down-remove the tank cap by turning it counter-clockwise. (Fig. 4) 3. Fill the water tank with clean, cool water (not cold). We Fig. 5 recommend using distilled water if you live in a hard water area. (Fig. 5) Fig. 6 4. Replace the tank cap by turning clockwise until tight. (Fig. 6) 5. Install both tanks back on the base of the unit.Make Fig. 7 sure the tanks are firmly seated. (Fig. 7) Note: This unit uses water from one tank at a time. It will use all the water from one tank before beginning to pull water from the other tank. Note: It is normal to have a small amount of water in the base during and after use. 7