Homelite UT13126 User Manual - Page 16
Call Us First - problems
View all Homelite UT13126 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
TROUBLESHOOTING Problem Handle not in position. Mower not starting. Possible Cause Carriage bolts not seated properly. Handle knobs not tightened. Battery is low in charge. Solution Adjust the height of the handle and make sure the carriage bolts are seated properly. Tighten handle knobs. Charge the battery. Battery is either defective or will not Replace the battery. take a charge. Mower cutting grass unevenly. Mower not mulching properly. Mower hard to push. Mower vibrating at higher speed. Lawn is rough or uneven or cutting height not set properly. Move the wheels to a higher position. All wheels must be placed in the same cutting height for the mower to cut evenly. Wet grass clippings sticking to the Wait until the grass dries before underside of the deck. mowing. High grass, rear of mower housing and blade dragging in heavy grass, or cutting height too low. Raise cutting height. Blade is unbalanced. Bent motor shaft. Balance the blade by grinding each cutting edge equally. Stop the motor, disconnect the power source, and inspect for damage. Have repaired by an authorized service center before restarting. CALL US FIRST For any questions about operating or maintaining your product, call the Homelite® Help Line! Your product has been fully tested prior to shipment to ensure your complete satisfaction. Page 16