Homelite UT905700 User Manual - Page 15

ASSEMBLY UNPACKING This product requires assembly.  Carefully cut the box down the sides then remove the machine and any accessories from the box. Make sure that all items listed in the packing list are included. NOTE: This machine is heavy and requires a minimum of two people to lift. To avoid back injury, lift with your legs and not your back. WARNING: Do not use this product if any parts on the Loose Parts List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury.  Inspect the unit carefully to make sure no damage occurred during shipping.  Do not discard the packing material until you have ­carefully inspected and satisfactorily operated the ­product.  If any parts are damaged or missing, please call 1-800-242-4672 for assistance. WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury. LOOSE PARTS LIST See Figure 2. The following items are included with the generator: Key No. Description Qty. 1 Bolt (3/8-16 x 4-1/4 in 2 2 Washer (3/8 in 2 3 Spacer (.38 ID 2 4 Wheel 2 5 Lock Nut (3/8-16 2 6 Handle Lock Pin 2 7 Lanyard 2 8 Lock Nut (1/4-20 2 9 Washer (1/4 in 2 10 Rubber Foot 2 11 Bolt (1/4-20 x 1-1/2 in 2 12 Flange Nut (5/16-18 2 13 Washer (5/16 in 4 14 Bolt (5/16-18 x 1 in 2 15 Frame Support 1 16 Engine Lubricant 1 17 Bolt (5/16-18 x 2-1/4 in 2 18 Lock Nut (5/16 2 19 Handle 2 20 Handle Bracket Spacer 2 Operator's Manual (not shown 1 TOOLS NEEDED See Figure 3. The following tools (not included or drawn to scale) are needed for assembly:  7/16 in., 1/2 in., and 9/16 in. Socket Wrench  7/16 in., 1/2 in., and 9/16 in. Combination Wrench NOTE: Do not put fuel or lubricant in the generator before installing the feet, frame support, and wheels. INSTALLING FEET ON THE FRAME SUPPORT See Figure 4.  Locate the following items: 2 rubber feet 2 lock nuts (1/4-20) 2 washers (1/4 in.) 2 bolts (1/4-20 x 1-1/2 in.)  Insert bolt through foot, then through frame support as shown.  Slide a washer on the bolt, then install nut. Tighten nut securely. NOTE: Be careful not to overtighten so that foot material collapses.  Repeat with remaining foot. Page 11 - English