Honeywell 191108AJ Owner's Manual - Page 11
To set the heating program
View all Honeywell 191108AJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
temperature (comfort period); a blue pin is inserted at 10:00 PM for low temperature (energy saving period). Two additional sets of pins are located in the program pin storage area. You can set up to six temperature changes with the pins supplied. We recommend at least five hours for each energy saving period. ■ To change the pins or add a new energy savings period: • To insert a pin, push it straight into the selected notch on the program dial until it is completely seated. • To remove a pin, press against the program dial and pull the pin straight out. DO NOT attempt to change a pin if it is engaged with the program index wheel. • On heating/cooling systems, set the subbase switches to desired positions. See Setting Subbase Switches section. • On heating/cooling systems, you must reset the pins when the seasons change. You will also probably want to change the lever positions. To set the heating program: ■ Decide when you want the temperature to reach the comfort level. Find the notch on the dial that is one-half hour before this time and insert a red pin. The high temperature is in effect. The half-hour head start gives the furnace time to heat the house before you awaken or arrive home. ■ Decide when you want the energy saving period to start and insert a blue pin at the notch that corresponds to this time. After the blue pin engages, the low temperature is in effect. The furnace will be off until room temperature drops to the energy saving setpoint. ■ You can set both a day and a night program. See Fig. 5 for program examples. 11 69-0643-1