Honeywell 2020-5BE User Guide - Page 25
Linking Image Scanner to Base, Image Scanner Modes, Unlinking the Image Scanner
View all Honeywell 2020-5BE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Linking Image Scanner to Base When newly shipped or defaulted to factory settings, the base and image scanner are not linked. Once the image scanner is placed into the base, the software automatically links the image scanner and the base. If the image scanner and base have previously been linked, you do not receive any feedback. If this is the first time that the image scanner and base are linked, both devices emit a short chirp when their radios link. At this point, you are set to one image scanner to one base. Image Scanner* Green LED Red LED 2020 Base *3820 shown 1. Provide power to the base. 2. Place the 3820/3820i into the base. The image scanner and base link. 3. To determine if your cordless system is set up correctly, scan one of the sample bar codes in the back of this manual. If the image scanner provides a single good read beep and the green LED lights, the image scanner has successfully linked to the base. If you receive a triple error beep and the red LED lights, the image scanner has not linked to the base. Image Scanner Modes The 3820/3820i is capable of working in single image scanner mode, multiple image scanner mode, or with Bluetooth devices, other than the 2020 base. Unlinking the Image Scanner If the base has an image scanner linked to it, that image scanner must be unlinked before a new image scanner can be linked. Once the previous image scanner is unlinked, it will no longer communicate with the base. To unlink an image scanner from the base, scan the Unlink Image Scanner bar code below. Unlink Image Scanner 1 - 5