Honeywell 6160 Setup Guide - Page 1
Honeywell 6160 - DELUXE 32-CHARACTER ALPHA KEYPAD Manual
UPC - 781410342088
View all Honeywell 6160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
K3590-ADV4 2/09 Rev. A ADEMCO 6150 & 6160 REMOTE KEYPADS INSTALLATION AND SETUP GUIDE Keypad Features Backlit Display Dedicated Function Keys ADEMCO 6150 Fixed-Word 9(see note) 9 ADEMCO 6160 2-Line Alpha 9 (see note) 9 Built-in Sounder Piezo Speaker Note: Permanent display backlighting is an option on some controls (see the control's instructions for details). GENERAL INFORMATION The ADEMCO 6150 and ADEMCO 6160 are addressable Remote Keypads designed for use with ADEMCO control panels. Addresses are set via the keypad keys. The keys on the keypads are continuously backlit for convenience. Supervised by control panel (if supported). KEYPAD DISPLAYS AND LEDS The keypads have the following display features: Model Fixed Word Display 2-line Alpha Display 2-digit Zone Identifier Custom Zone Descriptors 6150 X X 6160 X X The following table shows the LEDs and their functions: LED Red Green Function Lights when the system is armed in any mode Lights when the system is "ready" to be armed. SPECIAL FUNCTION KEYS The keypads also feature function keys. These keys may be programmed for panic alarms or other special functions such as macros. See the control's instructions for details. Function keys must be held down for at least 2 seconds to activate an alarm; key pairs are activated immediately. Function Keys A or [1] and [✻] B or [✻] and [#] C or [3] and [#] WIRING AND INSTALLATION The keypads can be surface mounted directly to a drywall, or to a single- or double-gang electrical box. 1. Push the two case release snaps at the bottom of the keypad with the blade of a medium screwdriver (this will push in the release snap), then pull that side of the case back away. Insert the screwdriver in the side of the keypad (between the front and back case) and gently twist to release the side locking tab. Repeat for the other side. Refer to Figure 1 for location of the case back release snaps and locking tabs. 2. Route wiring from the control panel through the opening in the case back. 3. Mount the case back to a wall or electrical box. 4. Wire directly from the keypad's terminal block to the terminal block on the control panel. (See Wiring Table below). NOTE: No more than one wire per terminal may be connected. If daisy-chained configuration is required, pig-tail wires together so that only one wire is terminated under the screw. Use 16-24 AWG wire only! Wiring Table (All Keypads) Keypad Control Panel SG Data In - - Aux Pwr (GND) + + Aux. Pwr TY Data Out Wire Color Green Black Red Yellow See the control panel's Installation and Setup Guide for more complete details. 5. Reattach the keypad to its case back. D