Honeywell CT3611 Owner's Manual - Page 19
Toll-Free Customer Assistance, Table 3. Solution Guide., Then° - problem
View all Honeywell CT3611 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
If... Display flashes during programming. Temperature change occurs at the wrong times. Display shows Wait. LED is on. Table 3. Solution Guide. Then... The temperature setting limit has been reached. The heating setting range is 40°F to 90°F (4.5°C to 32°C). The cooling setting range is 45°F to 99°F (7°C to 35°C). 1. Check the program times for the period in question. 2. Make sure the AM and PM settings are correct. 3. Make sure the current time and day settings are correct. 4. Reprogram any incorrect settings. NOTE: If your thermostat is set for Smart Response™ technology, the start times occur before your programmed comfort periods. The thermostat is in a compressor protection delay. Wait five minutes and check the registers again. If a separate wire is hooked to the L terminal it can be connected to a system monitor. If so, the light being on indicates a problem with the heat pump. Contact your local heating and cooling contractor. Toll-Free Customer Assistance Please read and follow the provided instructions for this thermostat. For additional information, go to www.honeywell.com/yourhome or call the Honeywell Customer Relations Center at 1-800-468-1502. The Center hours are Monday through Friday, 7:00AM to 5:30PM Central Time. Before calling, please have the following information available: • Thermostat model number. (Located on back of thermostat). • Thermostat date code. (Located below model number). • Type of heating/cooling system (for example, hot water, warm air, oil, or gas). • Location and number of wires connected to the thermostat. 19 69-1081-3