Honeywell HY-022 Installation Instructions - Page 2
Remote Control Battery Installation/Replacement, A. Fan Assembly, B. Remote Control Battery - fan manual
View all Honeywell HY-022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 2 HY-022 SERIES ASSEMBLY INSTRUCTIONS NOTE: Remove all contents from the box being careful not to discard the manual. Remote Control Battery Installation/Replacement • The remote control is located in the upper portion of the front housing. Press on the remote control until you hear a "click" sound to remove it from the recessed storage area in the fan (Fig 1). • Locate the tab on the side of the remote and gently squeeze the tab and pull away from the remote (Fig 2). • Remove the clear plastic protective sticker from the Lithium CR2025 battery and place the battery back in the holder and push the holder back into the remote. Make sure the (+) side is facing upward. • To store the remote control, insert it back into the opening located on the front of the fan. You will hear a "click", indicating the remote is properly stored. • The fan is now ready to be used. Note: When replacing the battery, please follow the above instructions. Fig. 1 Fig. 2 HY-026 SERIES/HY-030 SERIES ASSEMBLY INSTRUCTIONS NOTE: Remove all contents from the box being careful not to discard the manual and hardware needed for assembly. A. Fan Assembly • Align the rear and front base assembly and firmly snap together by Fig. 3 pushing the 4 round extrusions into the adjacent circles of the connecting pieces (Fig 3). • Use a phillips head screw driver ( ) to secure the rear and front base assemblies together using the two (2) smaller 3mm screws included with the fan (Fig. 4). • Carefully turn the fan housing upside down. • Place the base onto the fan housing making sure the three screw holes located on the bottom of the fan line up with the holes on the base (Fig 5). • Locate the three (3) 5mm screws included with the fan and insert them into the holes on the bottom of the base and tighten with a phillips head screw driver ( ) (Fig. 6). Fig. 4 • Turn the fan right side up. B. Remote Control Battery Installation/Replacement • The remote control is located in the upper portion of the front housing. Press on the remote control until you hear a "click" sound to remove it from the recessed storage area in the fan (Fig 7). • Locate the tab on the side of the remote and gently squeeze the tab and pull away from the remote (Fig 8). Fig. 5 Fig. 6 • Remove the clear plastic protective sticker from the Lithium CR2025 battery and place the battery back in the holder and push the holder back into the remote. Make sure the (+) side is facing upward. Fig. 7 Fig. 8 • To store the remote control, insert it back into the opening located on the front of the fan. You will hear a "click", indicating the remote is properly stored. • The fan is now ready to be used. Note: When replacing the battery, please follow the above instructions.