Honeywell HY-022 Installation Instructions - Page 3

HY-022-026-030_OM.qxd 10/13/06 2:07 PM Page 4 OPERATION INSTRUCTIONS FOR UNIT AND REMOTE CONTROL Set-up • Place the fan on a level and dry surface. • Plug the power cord into a polarized 120 Volt AC wall outlet. Operation Instructions On/Off Activation: To turn the fan on, press the Power button once. A red light will illuminate behind the button indicating the power is turned on. Press the Power button again to turn the fan off. Speed Control: The fan will automatically start on the Low Speed setting upon the initial start-up. Low speed is indicated by a red illuminated speed control button. To adjust the speed, press the fan speed button once for Medium speed which will be indicated by a orange light behind the button, or twice for High speed which is indicated by a green illuminated button. Note: When the fan is turned off and restarted using the Power button, it will operate in the same speed setting that it was last set to. Oscillation Control: To activate the Internal Oscillation feature, press the Oscillation button once. Press the Oscillation button again to turn the Oscillation feature off. The feature, when activated, will be indicated by a red illuminated Oscillation button. Note: When in Oscillation mode, you will not see the fan rotating left to right. The oscillation mechanism is located inside the fan. Timer Feature: The auto shut-off timer can be set for 2, 4, or 8 hours. 2 hours: Press the Timer button once. The button will illuminate in red. 4 hours: Press the Timer button twice. The button will illuminate in orange. 8 hours: Press the Timer button a third time. The button will illuminate in green. Press the Timer button a forth time to turn the Timer feature off. Breeze Mode: (HY-022 and HY-026 only) To activate the Breeze mode, press the breeze button once. The button will illuminate in red. Note: The Breeze mode feature will simulate outdoor breezes by automatically increasing and decreasing the fan speed in a random manner. OPERATION INSTRUCTIONS FOR UNIT AND REMOTE CONTROL (CONTINUED) Fig. 9 Water Feature: (HY-030 only) With the fan in the off position and unplugged, remove the water tank from the lower portion of the fan (Fig 9). Fill the tank to the fill line (approximate 1/3 gallon). Fit the water tank securely back in to the recessed tank area. Turn the fan on. To activate the water feature press the Water Feature button once. The back-lit button will illuminate red. To turn the water feature off, press the Water Feature button a second time. Note: To scent the air add a few drops of scented oil to the water tank. CLEANING AND STORAGE • Unplug the fan before cleaning. • Use only a soft, damp cloth to gently wipe the outer surfaces of the fan clean. • To clean between the grilles, we recommend using a pipe cleaner, flexible dustwand, vacuum cleaner or compressed air to gently remove the dust. • DO NOT immerse the fan in water and never allow water to drip into the motor housing. • DO NOT use gasoline, paint thinner or other chemicals to clean the fan. • For storage, clean the fan carefully as instructed. Store the fan in the original packaging or cover the product to protect it from dust. Store the fan in a cool, dry place. CONSUMER RELATIONS Mail questions or comments to: Kaz, Incorporated Consumer Relations Dept. 250 Turnpike Road Southborough, MA 01772 Call us toll-free at: 1-800-477-0457 E-mail: [email protected] Or visit our website at: www.kaz.com Please be sure to specify a model number. NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE YOUR WARRANTY. DO NOT RETURN TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE.