Honeywell HZ-0300 Owners Manual - Page 3

HZ-0300_OM.qxd 10/25/06 3:11 PM Page 3 OPERATING INSTRUCTIONS (CONT'D) TO OPERATE THE FAN MODE: • Press the blue fan On/Off button ( ) on the top to turn the fan mode on. (The power light will not illuminate on the front of the product in the fan mode). • To operate your Turbo Air Circulator Fan, turn the fan control knob to the desired fan speed: HIGH (III), MEDIUM (II) or LOW (I). • Press the blue fan On/Off button ( ) to turn off and unplug the fan when you are finished using it. USING THE OSCILLATION FEATURE: Your HZ-0300 All Season Comfort™ Fan & Heater is equipped with an oscillation option. If you wish to use this feature, press the oscillation button ( ) and your unit will oscillate side to side. Push the oscillation button ( ) again to turn the oscillating feature off. SAFETY FEATURES The heater function is equipped with several devices and features for added protection. • A high temperature safety device (Hi Limit) prevents overheating of the heater. • A back-up safety thermal fuse. • A tip over switch so if the product were to tip over, and the air flow was blocked, the heater function would automatically turn off. TROUBLESHOOTING If your heater shuts off unexpectedly, safety features may have been activated to prevent overheating. If this happens: • Be sure the power cord is plugged into a working electrical outlet. • Check that the thermostat is not set too low. Turn the thermostat up until the heater starts. • Check for any obstructions. If you find one, turn the heater OFF and unplug it. Wait at least 10 minutes to allow the heater to cool completely before removing any obstruction. When done, plug in the heater and follow the OPERATING INSTRUCTIONS. CLEANING AND STORAGE We recommend that the All Season Comfort™ Fan & Heater be cleaned at least once a month. • Turn the heater and/or fan mode off and unplug the unit before cleaning. • Use only a dry cloth to clean the external surfaces of the product. DO NOT USE WATER, WAX, POLISH, OR ANY CHEMICAL SOLUTION. • The fan grille is removable for cleaning. Remove the 3 screws with a phillips head screwdriver and use only a dry cloth to clean the grill. Be sure the fan grille is in place with the screws tightly fastened before operating the fan. • DO NOT immerse the unit in water and never allow water to drip into the motor housing. • When not in use, pack the unit with the cord bundled in its original container and store in a cool, dry place. ELECTRICAL RATING This product is rated at 1500 watts 120V, 60Hz.