Honeywell HZ-338 User Guide - Page 2

BASIC CONTROL PANEL OPERATION: MODE: SET TIMER Timer POWER Continuous Run High Power Low Power • Press Mode until the Timer icon blinks. The Hour display will appear. • Use the Up or Down arrows to set an operation time between 1 and 10 hours. • The heater will turn-off when time runs out. • Press Power once to start the heater on High Power, Continuous Run. • Press Power again to change to Low Power, Continuous Run. FAHRENHEIT/CELSIUS • Press Power a third time to turn the heater off. MODE: SET TEMPERATURE Set Temperature • Press Mode until the Temperature icon blinks. The current room temperature will appear. • Use the Up or Down arrows to set the desired temperature. • The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. • The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. • The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. F/C Temperature Display • F/C feature functions from only the Power or Set Temperature screens. • Press the F/C button to toggle between Fahrenheit and Celsius. 2