Honeywell HZ709 Owners Manual - Page 2

Oil-filled_OM_rev3.qx 5/1/06 10:17 AM Page 2 IMPORTANT SAFETY INSTRUCTIONS REGARDING THE PLUG ON YOUR PRODUCT Fig. 1 ELECTRICAL RATING This product is rated 12.5 Amps (1500 W) at 120 VAC, 60 Hz. SET UP-WHEEL BASE ASSEMBLY NOTE: DO NOT OPERATE THE HEATER WITHOUT THE WHEEL BASE ASSEMBLIES IN PLACE. THE HEATER MUST ALWAYS BE USED IN AN UPRIGHT POSITION. DO NOT OPERATE THE HEATER IF THE WHEELS ARE NOT ASSEMBLED CORRECTLY. • Make sure the heater is unplugged and in the OFF position. • Turn the heater upside down to install wheels. • Push wheels into each wheel base pin, until you hear them snap into position. • While the heater is still upside-down, position the wheel base assemblies between the end fins. Attach them to the U-bolts on the heater and tighten using the wing nuts provided (Fig. 2). • Turn heater right-side up. Your heater is now ready for use. • Place the heater on a firm, level surface free from obstructions, and at least 3ft. (0.9m) away from any wall or combustible material. Fig. 2 (Bottom of Unit) Wheel Base Wheel Base Pin Wing Nuts U-bolts Correct Incorrect If the controls are located at the bottom and the Honeywell logo is upside down you have installed the wheels incorrectly (Fig. 3). NOTE: These heaters contain oil that is permanently sealed and will never require refilling or replacing. NOTE: THESE MODELS OF OIL-FILLED HEATERS MAY TAKE UP TO SEVERAL MINUTES TO REACH NORMAL OPERATIONAL TEMPERATURE. Fig. 3