Honeywell IS215T Installation Instructions

❶

Select the mounting location.

❹

Wire the unit.

❸

Mount the unit.

Mounting Location Guidelines

°

2.3 m (7±6²) mounting height

°

Avoid direct or reflected sunlight

°

Aim sensor away from windows or heating/

cooling devices

°

Sensor must have a clear line-of-sight to

protected area

°

Push outward on the

PCB latch and lift the

PCB out of the hous-

ing.

°

Slide the wire through the wire channel and wire

access in the back housing.

°

Mount the back housing flat against a wall or in a

corner.

°

Replace the PCB.

°

Connect wires as shown using 0.64 - 1.63 mm

2

(14 to 22 AWG) wire size.

Observe proper

polarity.

Corner

Mount

Wire Channel

Wall Mount

IS-215T Passive Infrared Motion Sensor Installation Instructions

❷

Separate the sensor housings and re-

move the printed circuit board (PCB).

Corner

Mount

Wiring Knockouts

POWER

12VDC

10mA

ALARM

16VDC

90mA

TAMPER

30VDC

0.5A

❺

Configure the sensor sensitivity.

°

Configure the IS-215T for the sensitivity best

suited to the application.

ON

OFF

SENSITIVITY

SWITCH SW2 POSITION

High (pulse count 1)

Low [Normal] (pulse count 2)

❻

Walk-test the sensor.

High Sensitivity:

2-4 Steps

(Pulse Count 1)

Switch

°

Use a small screwdriver to

push in the housing latch

at the bottom of the sensor,

and gently pull apart the

housings.

Alarm

LED

Low [Normal] Sensitivity:

3-5 Steps

(Pulse Count 2)

Honeywell IS215T Installation Instructions

Honeywell IS215T Manual

Honeywell IS215T manual content summary: