Honeywell IS215T Installation Instructions - Page 2

IS-215T Passive Infrared Motion Sensor Product Information ALARM LED DISABLE After walk-testing the sensor, disable the alarm LED by turning Switch S1 to the OFF position. DETECTION PATTERNS TOP VIEW Wide Angle Lens SPECIFICATIONS Range: 12 m x 12 m 40' x 40' Power requirements: 10 - 14 VDC, w/LED - Alarm: 10mA max.; w/o LED - Alarm: 7mA max.; 12 VDC 3V peak-to-peak at nominal 12 VDC Alarm relay: Form A SPST, 90 mA, 16 VDC, 15 Ohm protective resistor Tamper switch Closed with cover in place 0.5 A, 30 VDC RFI immunity: 30 V/m 10 MHz - 1000 MHz PIR White light immunity: 6,500 Lux PIR sensitivity: Switch selectable low [normal] (pulse count 2) 3-5 steps high (pulse count 1) 2-4 steps PIR fields of view: dual element, 44 long range zones 14 intermediate, 8 lower, 4 look-down Operating temperature: -10o C to +55o C (14° F to 131° F) Relative humidity: 5% to 95% noncondensing Dimensions: 8.57 cm x 6.03 cm x 3.81 cm (3-3/8" H x 2-3/8" W x 1-1/2" D) Weight: 66.62 g (2.35 oz) Packaged Product is 92.14 g (3.25 oz) Approvals/listings: CE cULus C-Tick EN 50131-1 Security Grade 2 Environmental Class II Important: For UL Certificated installations, the IS215T must be connected to a UL listed power supply or UL listed control unit capable of providing a minimum of four hours of standby power. Suitable for connection to an EN 60950 Class II Limited Power Source. SIDE VIEW Wide Angle Lens © 2004 Honeywell International Inc. • Honeywell and IntelliSense are registered trademarks of Honeywell International Inc. All other trademarks are the properties of their respective owners. All rights reserved. 5-051-680-40 Rev C