Honeywell T834N Owner's Manual - Page 4
Set fan switch except model T834L, Thermostat mounting, Set heat anticipator except model T834L
View all Honeywell T834N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
T834 Series Set fan switch (except model T834L) Fan operation settings: F: For gas or oil heating systems, leave the fan operation switch in this factory-set position (for systems that control the fan in a call for heat.) E: Change the switch to this setting for heat pump or electric heat systems. (This setting is for systems that allow the thermostat to control the fan in a call for heat, if a fan wire is connected to the G terminal.) Set heat anticipator (except model T834L) Move the adjustment arrow to the proper setting for your system (see table below). Your system Steam Hot water heat Warm air (high efficiency) Warm air (standard) Electric heat Setting 1.2 0.8 0.8 0.4 0.3 Thermostat mounting Align the slots on the cover with tabs on the sides of the base, then push gently until the cover snaps into place. Tab 4