Hoover F5871 Manual - Page 4

Assemble handle

Get Hoover F5871 PDF manuals and user guides View all Hoover F5871 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

The assembled cleaner will look like Assemble handle 1-3 this drawing. 1-2 A Attach upper handle Remove clean solution tank (upper tank) from carpet cleaner. 1-4 1-5 B With cord hook (A) to back of carpet cleaner, push upper handle down onto lower handle. Push bolts into holes on front of handle. If bolts will not go through hole easily handle is not pushed completely down. 1-6 C Attach hose holder Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure holes for bolts are aligned. 1-7 Place nuts in recessed areas on back of hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver. Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience. 1-8 When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod In place. 1-9 Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place. 4 Press cord into cord clip on back of handle. Pull cord tight. Attach tool holder Remove tool and taped screw from holder. Insert projections on rack into slots on back of cleaner.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
4
The assembled cleaner will look like
this drawing.
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from carpet cleaner.
With cord hook (A) to back of carpet clean-
er, push upper handle down onto lower
handle. Push
bolts
into holes on
front of
handle. If bolts will not go through hole
easily handle is not pushed completely
down.
1-3
1-6
1-7
1-8
1-4
1-5
1-9
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod In place.
A
C
B
Replace clean solution tank (upper
tank) by positioning bottom first. Press
on tank handle to snap top of tank into
place.
Press cord into cord clip on back of
handle. Pull cord tight.
Place
nuts
in recessed areas on
back
of hose holder.
Hold each nut in place
while tightening each bolt securely
(from the front of the handle) with a
Phillips screwdriver.
Only two nuts are needed on this
model. The extra nut is not required but
has been provided for your conve-
nience.
Attach tool holder
Remove tool and taped screw from
holder.
Insert projections on rack into slots on
back of cleaner.
Assemble handle