Hoover F5915100 Manual - Page 8

2-5 E 2-6 OAFgFitatoLrOSHpIeed 2-7 F G Automatic "shut off" When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the carpet cleaner suction (suction will be noticeably reduced). At that time the yellow float disk will rise to the top of the recovery tank lid (E). The carpet cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens turn carpet cleaner off and empty recovery tank before continuing use. Check clean solution tank also; it may need to be refilled. Brush speed selector Your SteamVac™ carpet cleaner has three agitator brush settings. Hl - for normal cleaning of carpet and bare floors LO - for gentle cleaning of carpets and bare floors OFF - for cleaning carpets and bare floors when brushing is not desired. (Such as when picking up liquid spills. See page 11.) Slide selector button to the desired setting before cleaning. Brush indicator The brush indicator will spin (F) when the carpet cleaner is turned ON and the brushes are rotating. If the indicator does not spin and the pattern is visible (G) when the carpet cleaner is turned ON, the brushes are not rotating. There are three reasons why the brushes may not be rotating: 1. Brush speed selector set on OFF (see previous section). 2. Solution tube connected (Fig. 3-10). 3. Brush indicator screen dirty (Fig. 2-8). 2-8 2-9 H 2-10 To clean screen (H), turn carpet cleaner off and disconnect from electrical outlet. Remove clear cover and wipe off screen with a damp cloth. Snap cover back into position. The tanks Clean solution tank (upper tank) The clean solution tank holds the cleaning solution that is to be dispersed onto the surface to be cleaned. How to fill Disconnect carpet cleaner from electrical outlet. Place carpet cleaner handle in the upright, locked position. To remove tank, press down on handle and pull forward. Carry tank to a sink. Rotate tank cap counterclockwise and lift up to remove cap. 8