Hoover F6039 Manual - Page 4

The assembled cleaner will look like this drawing. Assemble handle 1-3 A1 1-2 A2 Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. With hose hook (A1) and cord hook (A2) to back of deep cleaner, push upper handle down onto lower handle. Push bolts into holes on front of handle. If bolts will not go through hole easily handle is not pushed completely down. 1-4 1-5 1-6 B C Attach hose holder Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure holes for bolts are aligned. 1-7 Place nuts in recessed areas on back of the hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screw driver. Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience. 1-8 When handle sections are completely together, squeeze trigger (C) on upper handle. You will hear a "snap" when the trigger rod is in place. 1-9 D Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place. 4 Attach tool holder Remove tool and taped screw from holder. Insert projections on holder into slots on back of cleaner. Slide rack down into place. Insert screw at (D) and tighten with a Phillips screwdriver.