Hoover F7425-900 Manual - Page 8

2-5 2-6 2-7 B Carrying handle The deep cleaner may also be lifted by placing a hand above the upper clean solution tank handle as shown. Automatic shut off When the recovery tank (lower tank) is full the automatic shutoff mechanism will shut off the deep cleaner suction (suction will be noticeably reduced). At that time, the yellow float disk will rise to the top of the recovery tank lid (B). The deep cleaner will no longer pick up dirty solution and the motor sound will become noticeably higher in pitch. When this happens, turn deep cleaner off and empty recovery tank before continuing use. Check clean water tank also; it may need to be refilled. Do not use without float and float retainer in place. If broken or dislodged, take to an Authorized Hoover Service Center or Dealer for repair. Brush setting selector Your 'SteamVac' deep cleaner has two agitator brush settings. ON - for cleaning of carpet and bare floors OFF - for cleaning carpets and bare floors when brushing is not desired. Slide selector button to the desired setting before cleaning. 2-8 2-9 2-10 WASH AUTO RINSE OFF C D Rinse ON Rinse Setting switch Use this switch to select a wash with rinse setting or a rinse only setting. WASH-AutoRinse - This setting cleans your carpet with detergent and water on the forward stroke. On the reverse stroke, a water-only rinse is applied automatically. RINSE - This setting applies water-only rinse in both the forward and reverse strokes. See "How to clean" section for more details. The tanks Clean water tank (upper tank) The clean water tank (C) holds the water that will either be mixed with detergent for cleaning the carpet or floor, or used to rinse the carpet or floor. The detergent container (D) is permanently attached to the water tank. It holds the detergent that mixes with the water. How to fill Unplug deep cleaner from electrical outlet. Place deep cleaner handle in the upright, locked position. To remove tank, press down on tank handle and pull forward. 8