Hoover H2800 Manual - Page 11

4-4 4-5 Cleaning the brushes Turn cleaner OFF and disconnect from electrical outlet. The brush assembly can be removed for easy cleaning. 4-6 D E To replace nozzle, make sure latches While holding nozzle in place, slide are out. Align middle section (D) of latches inward to lock in place. nozzle with opening on cleaner. F Remove nozzle as described in Fig. 4-1 through 4-3. Using finger grips (E) on the brush assembly (F), pull straight out. The brush assembly can be washed with a mild detergent and rinsed. Do not use pine or solvent-based detergents. 4-7 H G Align tabs (G) on brush assembly with slots (H) in cleaner. Slide brush assembly into place. Replace nozzle as described in Figs. 4-4 and 4-5. Storage Before storing cleaner: Turn cleaner OFF and disconnect from electrical outlet. • Empty and rinse solution and recovery tanks. Allow to air dry. • Allow filter in recovery tank lid to dry. • Set the cleaner for "Dry Vacuuming" (pedal to "DRY" and Wet Control switch up). • Make sure that nothing is pressing on the nozzle squeegee. • Do not store cleaner on a wood surface unless cleaner is completely dry. Continued 11