Hoover H2800 Manual - Page 4
Cord clip - squeegee
View all Hoover H2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
1-3 1-4 B 1-5 C With cord hook (B) to back of cleaner, Insert two screws into back of handle push upper handle down onto cleaner. as shown. Tighten with a Phillips Insert screw with washer in front of screwdriver. tank area. Tighten screw with a Phillips screwdriver. Push brush control switch (C) down to connect switch rod. You will hear a "click" when the switch rod is in place. 1-6 1-7 1-8 E D G G Replace clean solution tank by positioning bottom first. Press latch and snap top portion into place. F H To install brush assembly and nozzle, place handle in upright position. Align tabs (D) on brush assembly with slots (E) in cleaner. Slide brush assembly (F) into place. To install nozzle, make sure latches (G) are out. Align middle section (H) of nozzle with opening on cleaner. 1-9 1-10 I While holding nozzle in place, slide latches inward to lock in place. Remove cardboard packing insert from squeegee area on underside of nozzle. Cord clip To help keep the cord out of the way while cleaning, position cord down into cord clip (I), located on the handle. 4