Hoover PowerScrub XL Pet Product Manual English - Page 3
Caution, Warning, Important - carpet cleaner machine
View all Hoover PowerScrub XL Pet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
OPERATION MAINTENANCE HOW TO USE TOOLS CAUTION: To reduce the risk of injury from moving parts - Unplug before connecting SpinScrub® Hand Tool. Not to be used for grooming pets. WARNING: To reduce the risk of personal injury, unplug before cleaning or servicing. IMPORTANT: To prevent possible leaking, remove Clean Water Tank and Dirty Water Tank. BRUSH CARE 1 Remove the tanks and place the handle in the upright position, tilt the cleaner back until handle rests on the floor. This product contains no serviceable parts. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call customer service at 1.800.944.9200 prior to continuing use. 1 Place the handle in the upright position. This will shut off the SpinScrub® brushes. 2 Connect tool to hose by sliding it onto the connector until it locks into place. 3 Using your thumb, push forward and up on the latch to remove tool. NOTE: The Antimicrobial pet tool included with select models only has a button to release the tool from the hose. 4 Turn cleaner ON. 5 Pre-spray the carpeted stair by holding the tool about one inch above the carpet and push it forward while pressing the trigger. LUBRICATION: The motor is equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor bearings. CORD STORAGE: Wrap the power cord around the cord hooks for convenient storage. Attach the plug end to the cord. NOZZLE CARE 1 First turn off and unplug the carpet cleaner. Remove Recovery Tank. 2 Push the latches out on the side of the foot until they lock open. 3 The Brush assembly should be free to pull out. 4 Rinse the brushes under running water. 5 Replace them by aligning the center drive post and note the arrows indicating the front of the machine. Push firmly until the latches lock into place. 6 Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly over the carpet. Release trigger at end of stroke. 7 Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger. NOTE: Overlap strokes by 1/2 inch to help prevent streaking. 2 Pull up on the Nozzle slightly to unsnap, then pull the Nozzle forward to remove it from carpet cleaner. Rinse with water and allow to air dry. 3 To replace it, position Nozzle onto the front end while making sure to align the tabs at the bottom of the Nozzle with the notches on the foot. 4 Snap Nozzle to foot and rotate the latch into the lock position. IMPORTANT: The nozzle must be in the proper position for the Dirty Water Tank to go on properly and for the unit to have proper suction. TROUBLESHOOTING WARNING: To reduce the risk of personal injury, unplug before cleaning or servicing. CAUTION: To reduce the risk of injury from moving parts - Unplug before servicing. Do not use cleaner without brushes in place. THIS PRODUCT CONTAINS NO SERVICEABLE PARTS. IF APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED, DAMAGED, LEFT OUTDOORS, OR DROPPED INTO WATER, CALL CUSTOMER SERVICE AT 1-800-944-9200 PRIOR TO CONTINUING USE.