Hoover SH80005CA Manual - Page 7

Hose Inlet Port, Multiple Intake Ports, Check The System - central vacuum

Page 7 highlights

Hose Inlet Port 3.4 Insert the hose into the hose inlet (A). The power unit is turned ON and OFF with the switch found on the upper section of the motor module. If you have a hose without switches, the Power Canister will start as soon as the hose is inserted into the wall valve. If you have a hose with a switch, then the Power Canister can be turned ON or OFF with the switch. The Power Canister can also be turned ON and OFF with the switch found on the upper section of the motor module. 3.4 A Multiple Intake Ports 3.5 The Power Canister is equipped with two (2) Intake Ports on the back. Once installation of the Central Vac System is complete, the intake port that was not used must be capped with the Vac Cap Assembly. This assembly is packed in the dust container of your Power Canister. 3.5 Check the System Check each connection for proper seal and that no air leaks occur. If one is present, you may hear a "hissing" sound. Correct if present. Check each inlet valve for air leaks. Start the system by plugging the hose into each valve to make sure it functions properly. Your Central Vacuum Cleaning System is now ready for your use. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33

7
3.4 Insert the hose into the hose inlet (A). The power unit is turned ON and OFF
with the switch found on the upper section of the motor module.
If you have a hose without switches, the Power Canister will start as soon as
the hose is inserted into the wall valve.
If you have a hose with a switch, then the Power Canister can be turned ON or
OFF with the switch.
The Power Canister can also be turned ON and OFF with the switch found on
the upper section of the motor module.
HOSE INLET PORT
3.4
A
MULTIPLE INTAKE PORTS
3.5 The Power Canister is equipped with two (2) Intake Ports on the back. Once
installation of the Central Vac System is complete, the intake port that was not
used must be capped with the Vac Cap Assembly. This assembly is packed in
the dust container of your Power Canister.
3.5
CHECK THE SYSTEM
Check each connection for proper seal and that no air leaks occur.
If one is present, you may hear a “hissing” sound. Correct if present. Check
each inlet valve for air leaks.
Start the system by plugging the hose into each valve to make sure it functions
properly.
Your Central Vacuum Cleaning System is now ready for your use.