Hoover U6485 Manual - Page 13
Warning - belts
UPC - 073502029138
View all Hoover U6485 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
BeltS The belts are located under the bottom plate of the cleaner and should be checked from time to time to be sure they are in good condition. The flat (wide) belt is described below; the other is described under "Brushroll replacement". When to Replace 3.9 To check the flat belt, remove bottom plate as shown. Replace belt if it is stretched, cut or broken. How to Replace ! WARNING ! Agitator brushroll can start suddenly. Unplug cleaner before turning it over. 3.9 A 3.11 3.9 Place handle in low position and turn cleaner over so bottom side is up. Remove the 4 screws as shown with a Phillips screw driver. Lift off bottom plate (A). 3.10 Flat belt (B) operates the self-propel feature and indirectly drives the brushroll. Remove used belt (B) from large pulley (C) and discard. 3.11 With lettering on outside of belt, slide new belt over motor shaft (D). 3.12 Place other end of belt over large pulley (C) while rolling the pulley in direction shown. 3.13 Reposition bottom plate and 4 Phillips head screws. Tighten screws securely. D 3.13 What to Buy: Belt Use only genuine HOOVER® belts with your cleaner. When purchasing a new belt, ask for Flat belt - HOOVER® part No. 38528035. If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200. 3.10 B C 3.12 C 13 Actual model may vary from images shown.