Hoover UH70070 Manual - Page 8
Belt replacement, Final filter, Headlight replace
View all Hoover UH70070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Final filter How to clean Disconnect cleaner from electrical outlet. Do not operate cleaner without dirt cup or filters in place. 3-9 A B Remove dirt cup as described in Fig. 3-2. Pull filter frame (A) straight out from bottom of dirt cup cavity. Do not attempt to remove filter (B) from frame. Hand wash in cold water with a mild detergent. Allow to air dry for 24 hours before replacing frame into bottom of dirt cup cavity. What to buy When purchasing new filters, ask for: Secondary filter-white fabric filter, HOOVER part No. 93002520. Final filter assemby, HOOVER part No. 93002521. Headlight replacement What to buy This cleaner uses a 13 volt, T-3 114 wedge base bulb, Hoover part No. 27313107. 3-10 Removing lens Disconnect cleaner from electrical outlet. Press handle release pedal and place handle in low position. Using a Phillips screwdriver, remove the the screw as shown and lift off lens. 3-11 Installing bulb Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Excessive force is not required. 3-12 Replacing lens Reposition lens and secure with the screw. 8 Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace Disconnect cleaner from electrical outlet. To check belt, remove hood as shown in Fig. 3-13. Replace belt if it is stretched, cut or broken. What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for HOOVER part No. 38528040 (belt package part No. 40201190). 3-13 A A How to replace Disconnect cleaner from electrical outlet. Removing hood Press handle release pedal and place handle in low position. Using a coin, turn the two slots (A) on either side of the hood as shown.