Hoover UH70100RM Product Manual - Page 12
When To Replace, How To Replace, Stretch Belt: What to Buy
View all Hoover UH70100RM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Belt ! CAUTION ! To reduce the risk of injury from moving parts, unplug vacuum before servicing. 4.19 The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. When To Replace Replace belt if it is stretched, cut or broken. To check the Stretch belt, refer to Fig. 4.22 - 4.24. How To Replace 4.19 Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counter clockwise. 4.20 Slide red lower latch (B) to the unlock position. 4.21 Lift off bottom plate. 4.22 Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard. Stretch Belt: What to Buy Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt, ask for Stretch Belt - HOOVER® part No. 38528033. 4.21 4.23 4.23 With lettering on outside of belt, slide new belt over motor shaft (metal rod) (E), then slip around area of brushroll without bristles (F). With belt in place, pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation. IMPORTANT Rotate brushroll manually to make sure belt is not twisted. 4.24 Reposition bottom plate, aligning tabs along front edge of nozzle guard with slots in nozzle. Rotate back into position. Slide red lower latch to Lock position, and rotate red upper latch clockwise. A E F 4.20 B 4.22 DC 4.24 12