Hoover UH70100RM Product Manual - Page 13

5. TROUBLESHOOTING If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. Any other servicing should be done by an authorized service representative. ! WARNING ! To reduce risk of personal injury - unplug vacuum before servicing. PROBLEM Vacuum won't run System Check Indicator has turned red or Vacuum won't pick up or Low suction Dust escaping from vacuum Powered Hand Tool brushroll won't turn Smoky/burning smell detected POSSIBLE CAUSE POSSIBLE SOLUTION 1. Power cord not firmly plugged 1. Plug unit in firmly. into outlet. 2. Blown fuse or tripped breaker. 2. Check fuse or breaker in home. Replace fuse/reset breaker in home. 3. Thermal Protector activated. 1.Rinsable Filter and/ or Filter made with HEPA media is dirty. 3. Unplug and allow vacuum to cool for 30min. (This willl reset the thermal protector) 1. Clean Rinsable Filter and or Filter made with HEPA media - Pg.9 2. Dirt Cup full and/ or clogged. 2. Empty Dirt Cup - Pg.8. 3. Broken or worn Belt. 4. Brushroll and/ or Hose clogged. 3. Replace Belt - Pg.12. 4. Check Hose - Pg.11. Check Brushroll - Pg.10. 5. Carpet height setting is incorrect. 5. Set Carpet Height Adjustment to appropriate setting for carpet being cleaned - Pg.7. 1. Dirt Cup full. 2. Dirt Cup not installed correctly. 1. Empty Dirt Cup - Pg. 8. 2. Review Dirt Cup removal & replacement Pg. 8. 3. Hose not installed correctly. 3. Review Hose installation - Pg. 7. 4. Rinsable and/ or Filter made with HEPA media not installed completely. 1. Too much pressure being applied to tool. 4. Review Filter Removal and Cleaning. 1. Continue using tool applying light pressure. 2. Blockage. 2. Remove blockage - Pg. 11 3. Low vacuum suction. 1. Belt broken or stretched. 3. Check items under "Vacuum won't pick or Low suction." 1. Replace brushroll belt - Pg. 12. 2. Brushroll is clogged. 2. Clear/ remove debris from brushroll - Pg. 10. 13