Hoover UH72630 Product Manual - Page 15
Warning - belt
View all Hoover UH72630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
5. TROUBLESHOOTING If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. Any other servicing should be done by an authorized service representative. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior to continuing use. ! WARNING ! To reduce the risk of personal injury Unplug before cleaning or servicing. PROBLEM POSSIBLE CAUSE Vacuum won't run 1. Power cord not firmly plugged into outlet. POSSIBLE SOLUTION 1. Plug unit in firmly. 2. Blown fuse or tripped breaker. 2. Check fuse or breaker in home. Replace fuse/reset breaker in home. 3. Thermal Protector activated. 3. Unplug and allow vacuum to cool for 30min.(This willl reset the thermal protector) System Check Indicator has turned red or Vacuum won't pick up or Low suction 1.Rinsable Filter and/ or Filter 1. Clean Rinsable Filter and or Filter made made with HEPA media is dirty. with HEPA media - Pg. 11. 2. Dirt cup full and/ or clogged. 2. Empty dirt cup - Pg. 10. 3. Broken or worn belt. 3. Replace belt - Pg.14. 4. Brushroll and/ or Hose clogged. 4. Check Hose - Pg. 13. Check Brushroll Pg. 12. 5. Carpet height setting is 5. Set Carpet Height Adjustment to appropri incorrect. ate setting for carpet being cleaned - Pg.7 6. Suction Only Mode is ON. 6. Step on Brushroll ON/OFF Pedal to turn Suction Only Mode OFF - Pg. 6. 7. Valve dial may be partially turned 7. Turn valve dial to FLOOR or HOSE mode. and/or not in proper mode. - Pg. 7 Dust escaping from vacuum 1. Dirt cup full. 2. Dirt cup not installed correctly. 1. Empty dirt cup - Pg. 10. 2. Review Dirt Cup removal & replacement Pg. 11. 3. Hose not installed correctly. 3. Review Hose installation - Pg. 8. 4. Rinsable and/ or Filter made with HEPA media not installed completely. 4. Review Filter Removal and Cleaning - Pg. 11. Headlight not working 1. Bulb burnt out. 2. Loose electrical wires. Vacuum is 1. Carpet height setting is difficult to push or incorrect. won't move forward 2. Brushroll is activated. 1. Replace bulb - Pg. 13. 2. Call 1-800-944-9200 for nearest authorized Hoover® dealer. 1a. Set Carpet Height Adjustment knob to appropriate setting for carpet being cleaned - Pg. 7. 2. For very high pile carpet deeper than 1", turn brushroll off. Turbo Tool brushroll won't turn Smoky/burning smell detected 1. Too much pressure being applied to tool. 1. Continue using tool applying light pressure. 2. Blockage. 2. Remove blockage. 3. Low vacuum suction. 3. Check items under "Vacuum won't pick up or Low suction." 4. Valve dial may be partially turned 4. Turn valve dial to FLOOR or HOSE mode. and/or not in proper mode. - Pg. 7 1. Belt broken or stretched. 1. Replace brushroll belt - Pg. 14. 2. Brushroll is clogged. 2. Clear/ remove debris from brushroll - Pg. 12. 15