Hoover WindTunnel 3 High Performance Pet Upright Vacuum Product Manual - Page 14

BELT ! CAUTION ! To reduce the risk of injury from moving parts Unplug before servicing The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition When To Replace Replace belt if it is stretched cut or broken To check the belt refer to Fig 4 26 4 28 How To Replace 4 23 Turn vacuum over so bottom side is facing up and remove the (6) screws (A) 4 24 Pivot out bottom plate away from hidden latch (B) 4 25 Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard What to Buy: Belt Use only genuine HOOVER® belts with your vacuum When purchasing a new belt for models with Brushroll On/Off (Suction Only Mode) ask for Flat Belt HOOVER® part No. 562289001 or AH20065 f desired additional belts can be purchased at Hoover com or 1 800 944 9200 4 26 With lettering on outside of belt slide new belt over motor shaft (metal rod) (E) 4 27 Remove any debris and/or hair from the brush roll Then slip other end of belt around area of brushroll without bristles (F) With belt in place pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation 4 28 Reposition bottom plate aligning latch (B) and fastening all (6) screws (A) Press firmly at latch (B) area to ensure that it is properly latched LUBRICATION: The motor and brushroll are equipped with bearings which contain sufficient lubrication for their lifetime The addition of lubricant could cause damage Do not add lubricant to motor or brushroll 4.23 A 4.24 4.25 D B 4.26 E C 4.27 4.28 A F B IMPORTANT Rotate brushroll manually to make sure belt is not twisted 14 Actual model may vary from images shown.