Hotpoint GSM1800NBB Installation Instructions - Page 13

Installation Instructions STEP 16 DISHWASHER WET TEST Turn on power supply (or plug power cord into outlet, if equipped). Turn dial to Normal "Wash" position. Close door. Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power are turned on. Check for leaks under the dishwasher. If a leak is found, turn power supply off, then tighten connections. Restore power after leak is corrected. Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dishwasher if necessary. See Step 9. The dishwasher will drain and turn off about 5 to 7 minutes after the first fill. Check drain lines. If leaks are found, turn power off at the breaker and correct plumbing as necessary. Restore power after corrections are made. See Step 12. Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. See Step 13. Also check drain line for kinking. Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required. At the end of drain, open door and turn dial to OFF position. STEP 17 REPLACE TOEKICK Figure Z Use Top 4 Screw Holes 2-Piece Toekick Adjust Up or Down • Place 2-piece toekick against the legs of the dishwasher. • Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw holes. Allow the toekick to touch the floor. • Place larger toekick over the inner piece and install 4 toekick screws. • Use additional 2 screws for installations over 33-1/2" high. • Use both toekick pieces for all installation heights. STEP 18 LITERATURE Be sure to leave complete literature package and installation instructions with consumer. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Pub. No. 31-30566 Dwg. No. 206C1559P106 Printed in China 07-03 JR