Hotpoint HTX26EASWWW Installation Instructions - Page 18

Installation Instructions REVERSING THE DOOR (cont.) A REVERSING THE DOOR - SOLID DOOR MODELS (cont.) 5 GTX52 model only: Remove 2 hinges and 8 screws (4 for the hinges and 4 for the outer door). Remove the inner door by lifting it up, using a flat blade screwdriver, and out. Hinges and Screws Outer Door Screws A REVERSING THE DOOR - SOLID DOOR MODELS (cont.) 8 Mount the door on the 2 upper left side hinge screws installed in step 2. Move the hinge screws loosened in step 3 into the lower left side screw holes and firmly tighten all 4 screws. Hang door and tighten screws Door Inner Door Outer Door Screw Outer Door 6 GTX52 model only: Flip the inner door over. Remove the dock by squeezing its tabs and pulling it out. Remove the latch catch by sliding down and pulling it out. Switch and install in the opposite positions. 4 Switch and install in opposite 3 positions 1 Squeeze and pull out 2 Slide down and pull out 7 GTX52 model only: Flip the inner door back over and rotate it 180°. Replace it back into the outer door. Replace the 2 hinges and 8 screws (4 for the hinges and 4 for the outer door). 9 Install the 4 plastic caps removed in step 1 into the 4 right side front panel holes. Plastic Cap (4) Right side of front panel NOTE: To return the door to the original setup, follow these instructions, swapping "left" and "right". When you finish Plug the dryer back into its electrical outlet. 18