Hunter 20775 Owner's Manual - Page 6

3 • Assembling and Hanging the Fan WARNING: Fan may fall if not assembled as directed in these installation instructions. Steps 3-1 - 3-2 You can assemble your fan for standard or angled mounting as shown in steps 3-1 - 3-4. For low profile mounting (ceilings less than 8 feet high), go to steps 3-5 - 3-11 on the next page. For Standard or Angled Mounting: 3-1. Unbundle the wires from the fan. 3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod. 3-3. Loosen the square head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. 3-4. Raise the fan and place the hook on the downrod through the loop on the ceiling plate. The arrows on the downrod and on the ceiling plate should both be pointing toward the tab hole on the canopy. Go to 4 • Wiring the Fan. Loop Step 3-4 Downrod Canopy Canopy Trim Ring Setscrew Downrod with Hook 6 42508-01 • 09/23/08 • Hunter Fan Company