Hunter 20775 Owner's Manual - Page 8

4 • Wiring the Fan All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes. 4-1. Make sure the power to the outlet box and associated wall switch location is still OFF. To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist clockwise until tight. CAUTION: Be sure no bare wire or wire strands are visible after making connections. Dual Switch Wiring: • The bare or green ground wire from the ceiling to the green ground wire from the ceiling plate and the green ground wire from the fan • The white wire from the ceiling to the white wire from the fan • The black wire from the ceiling to the black wire from the fan • The black/white wire from the ceiling to the black/white wire from the fan Single Switch Wiring: If you want to, you can control both fan and light with one switch. To do so connect the wires as follows: • The bare or green ground wire from the ceiling to the green ground wire from the ceiling plate and the green ground wire from the fan • The white wire from the ceiling to the white wire from the fan • The black wire from the ceiling to the black and the black/ white wire from the fan 4-2. Push all wires and wire connectors back through the ceiling plate hole into the outlet box. Wire Connector Dual Switch Wiring Single Switch Wiring 8 42508-01 • 09/23/08 • Hunter Fan Company