Hunter 20808 Installation Instructions - Page 3
Step 6: Final Wiring, Step 7: Finish Fan Assembly, Step 8: Fan Blade Assembly, Installation,
View all Hunter 20808 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Step 6: Final Wiring A. Connect electrical supply leads to the leads from the motor, using approved connectors. 1. Connect black electrical supply lead to the black motor lead and the black with white stripe motor lead (see note). 2. Connect the white electrical supply lead to the white motor lead. 3. Connect the ground wire to the green leads. NOTE: If a separate wall switch will be used to control a lighting accessory, connect the black wire with a white stripe to the wall switch lead, following wiring instructions included with the accessory. The wall switch must be acceptable for use as a generaluse switch. CAUTION: No bare wire or wire strands should be visible after making connections. B. After making the wire connections, all wires must be pushed back up into the outlet box. The splices should be turned upward. The wires should be spread apart with the white and the green wires on one side of the outlet box, and the black and black/white wires on the other side of the box. NOTE: If the wires are not pushed up into the outlet box they could strike the motor when it operates. Step 7: Finish Fan Assembly A. Using two 8-32 by approximately 5/8" long screws, from sack parts, thread the plastic hanger locking screws into the back of the hanger bracket. See Figure 6. The screws should be driven all the way into the bracket and tightened. The screws are located just above the plastic hanger and prevent the motor from twisting when the blades are assembled. B. Place the fan housing over the motor assembly and fasten the housing to the ceiling plate using the four screws provided (two each side). See Figure 6A. ASSEMBLY SCREWS FAN HOUSING FIGURE 6A Check and make sure the motor clears the opening in the bottom of the housing. Step 8: Fan Blade Assembly, Installation, and Balancing A. Attach wood blades to blade brackets using three screws for each blade. See Figure 7. If your blades have large holes you must first insert the rubber grommets into the holes. See Figure 7A. NOTE: Grommets are usually assembled by hand. If you use a tool, make certain you do not damage the grommet or blade when inserting the grommets. Next assemble the blade to the blade bracket. Make sure all screws are tight to prevent vibration or wobbling. A cavity in the styrofoam packaging has been provided to nest the parts in during assembly to assure correct alignment of parts. Even when the screws are tight, the blades may seem to be loose. This is normal when using grommets and will not be a problem. BLADE LOCKING SCREWS FIGURE 7 GROMMET FIGURE 7A FIGURE 6 Check and make sure all wiring is tucked up into the outlet box. B. If there are screws in the motor hub, remove them and use the screws to attach the blades to the motor. If the motor does not have screws, you will find them in sack parts. Insert a mounting screw in hole in blade bracket. Use a screwdriver to hold in place. Align blade holes with mounting holes in hub by turning screw and readjusting blade bracket until screw mates with threaded hole in hub. Do not tighten until both screws have been put in blade bracket. Repeat for all blades. See Figure 8. FORM NO. 41068-01 8/95 - 3 - ©1995 HUNTER FAN CO.