Hunter 20808 Installation Instructions - Page 4

PULL CHAIN SWITCH REVERSING SWITCH BREAKAWAY CONNECTOR BLADE MOUNTING SCREWS PURCHASED ACCESSORY CHAIN (IF DESIRED) INTEGRAL LIGHT KIT NOTE: MAKE CERTAIN ALL SCREWS ARE TIGHT. FIGURE 8 C. A blade balancing kit has been provided with your fan. Should the fan wobble in operation, you may use this kit to correct the balance per the instructions supplied with the kit. Step 9: Light Kit Installation A. Install the light kit in accordance with the instructions sup- plied with it. B. If your fan has a switch housing with an integral light kit as shown in Figure 8, install bulb using guide for maximum wattage printed on light kit and install globe, using the 3 thumb screws provided. Step 10: Operation of Fan A. Turn electrical service on at main panel. B. Switch operates in this sequence: "High," "Medium," "Low," "Off." Pull chain slowly to operate. Also, release the chain slowly so as to prevent chain from flying up into blades, possibly resulting in damage to blades, or pull chain. The breakaway connector is designed to separate from the chain at a predetermined force. If this separation occurs, simply reinsert the connector. It can be reused again and again. See Figure 8. C. Motor is electrically reversible. When first operating fan, de- termine direction of air flow. If you wish to change direction, switch fan off and allow to stop. Slide reversing switch to the opposite position and switch fan back on. See Figure 8. Speed Control As an option, a wall mounted speed control switch is available from your Hunter dealer. PROBLEM TROUBLESHOOTING GUIDE PROBABLE CAUSE SOLUTION 1. Nothing happens; fan does not move.* 1. Power turned off or fuse blown. 2. Loose wire connections or wrong connections. 3. Motor reversing switch not engaged. 4. Pull chain switch not "on". 1. Turn power on or replace fuse. 2. Check all wire connections (turn power off while checking). 3. Push switch firmly to one side or the other. 4. Pull switch chain. *NOTE: If blades will not turn by hand, contact your nearest service representative. 2. Noisy operation. 1. Blade brackets loosely screwed to motor. 2. Blade screwed loosely to blade bracket. 3. Blade cracked. 4. Non-approved speed control being used. 1. Tighten screws until snug. 2. Tighten screws. 3. Replace all blades. 4. Change to approved speed control. 3. Excessive wobbling. 1. Unbalanced blades. 2. Loose blades or blade brackets. 3. Fan not secure on hanger assembly. 1. Use balancing kit (See Step 8C). 2. Tighten all screws. 3. Turn power off, support fan very carefully. Check hanger assembly. When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will disappear. ©1995 HUNTER FAN CO. FORM NO. 41068-01 8/95 - 4 - HUNTER FAN COMPANY ® 2500 FRISCO AVENUE MEMPHIS, TN 38114